2 in. Gasoline Engine Semi-Trash Water Pump

2 in. Gasoline Engine Semi-Trash Water Pump

K&B Rentals LLC · Pumps - Power Units · Available now · No reviews yet

  • No rental protection
  • Verified operator
  • Secure booking
K&B Rentals LLC · Cameron, Missouri
Map of where this machine is

This is a self-priming, gas-engine-driven water pump with 2" NPT suction and discharge ports, built for moving large volumes of water quickly on job sites. It's powered by a 212cc horizontal single-cylinder 4-stroke OHV engine with forced air cooling, delivering up to 158 GPM at zero head and a maximum head lift of 91 ft., with a maximum intake lift of 26 ft. for pulling water up from below grade. A ceramic mechanical seal supports durability under abrasive or gritty water conditions, and the pump comes with an intake strainer, hose clamps, and a spark plug wrench ready to connect to standard 2" hose. With a 0.9-gallon fuel tank, it runs roughly 3 hours at 50% load before refueling, making it practical for a half-day of continuous dewatering without constant attention. Contractors, landscapers, and site crews rent units like this for flooded excavations, basement or pond draining, irrigation transfer, and general site dewatering where portable, engine-driven flow is needed without access to electrical power. Renting avoids the upfront cost and maintenance of owning a dedicated engine-driven pump for occasional or seasonal water-moving tasks.

Best used for

  • Construction site dewatering
  • Flooded basement draining
  • Excavation pit pumping
  • Pond or pool draining
  • Irrigation water transfer
  • Emergency flood response

Specifications

Key spec: 158 GPM max flow · 91 ft. max head lift · 2" NPT suction & discharge

This unit · Year
2026
This unit · Condition
Good
This unit · Fuel type
Gasoline
Pump · Suction & Discharge Size
2" NPT
Pump · Maximum Flow at 0'
158 GPM
Pump · Maximum Head Lift at 0 Flow
91 ft.
Pump · Maximum Intake Lift at 0
26 ft.
Pump · Mechanical Seal
Ceramic
Pump · Included Accessories
Intake Strainer, Hose Clamps, Spark Plug Wrench
Engine · Displacement
212cc
Engine · Engine Type
Horizontal Single Cylinder 4 stroke OHV
Engine · Cooling System
Forced air cooled
Engine · Fuel Type
87+ octane stabilizer-treated unleaded gasoline
Engine · Fuel Capacity
0.9 Gallons 3.6 Liters
Engine · Engine Oil Type
SAE 10W-30 above 32° F / 5W30 at 32° F or below
Engine · Engine Oil Capacity
0.5 Quarts 0.5 Liters
Engine · Run Time @ 50% Load with full tank
3 hr.
Engine · Sound Level at 22 feet
104 dB
Engine · Bore x Stroke
70 mm x 55 mm
Engine · Compression Ratio
9:1
Engine · Rotation viewed from PTO
Counterclockwise
Engine · Spark Plug Type
NGK® BP-6ES / NHSP® / Torch® F6TC
Engine · Spark Plug Gap
0.027" - 0.031"
Engine · Valve Clearance Intake/Exhaust
0.002" - 0.004"
Engine · No Load Speed
3,800 ±100 RPM
Shaft · Shaft
3/4" x 2.41"
Shaft · Keyway
3/16" 4.76 mm
Shaft · End Tapped
5/16" - 24 UNF

Guides & videos

$82/day